Ramblin
Guru
- Joined
- Oct 28, 2010
- Messages
- 138
- Reaction score
- 9
@wardmundy
Your tutorials on configuring trunks and inbound/outbound routes have been very helpful
I have a vitelity trunk setup and can dial out and in with 2-way voice.
I see in your post
http://nerdvittles.com/?p=20675
that you have a number of tutorials for other trunk providers.
I have about 6 trunks from Unlimitel
(a good Canadian provider - at least they were before the Primus takeover)
and they provide a great configurator for asterisk and FreePBX at
http://www.unlimitel.ca/temp/support/voip_support/voip_configuration_samples.html
http://www.unlimitel.ca/temp/support/voip_support/voip_configuration_samples.html
I have used that to help configure my PBXiaf and it works fine.
I cannot make the translation to Wazo.
Any chance you could help with translating the FreePBX configuration shown in the configurator to what the inputs are for Wazo? In the configurator, I entered:
and this for the trunk In settings
Unlike Vitelity, you enter this all in one configuration with FreePBX, but I am not sure if that is also true for Wazo.
Your tutorials on configuring trunks and inbound/outbound routes have been very helpful
I have a vitelity trunk setup and can dial out and in with 2-way voice.
I see in your post
http://nerdvittles.com/?p=20675
that you have a number of tutorials for other trunk providers.
I have about 6 trunks from Unlimitel
(a good Canadian provider - at least they were before the Primus takeover)
and they provide a great configurator for asterisk and FreePBX at
http://www.unlimitel.ca/temp/support/voip_support/voip_configuration_samples.html
http://www.unlimitel.ca/temp/support/voip_support/voip_configuration_samples.html
I have used that to help configure my PBXiaf and it works fine.
I cannot make the translation to Wazo.
Any chance you could help with translating the FreePBX configuration shown in the configurator to what the inputs are for Wazo? In the configurator, I entered:
- the Unlimitel server (pick any one, I can work with that as a sample)
- DID (anything will do; I can translate - I used 5195551212 to test it out)
- Password: MySecret
- CallerID NAME: WardMundy
- Server type: Choose Asterisk or TrixboxCE (Works for PBXiaf as well) for FreePBX interface
Code:
disallow=all
allow=ulaw
canreinvite=no
context=from-pstn
dtmfmode=rfc2833
host=sip06.unlimitel.ca
username=5195551212
secret=MySecret
insecure=very
progressinband=no
relaxdtmf=yes
rfc2833compensate=yes
type=peer
and this for the trunk In settings
Code:
disallow=all
allow=ulaw
canreinvite=no
context=from-pstn
dtmfmode=rfc2833
host=sip06.unlimitel.ca
username=5195551212
secret=MySecret
insecure=very
progressinband=no
relaxdtmf=yes
rfc2833compensate=yes
type=peer
Unlike Vitelity, you enter this all in one configuration with FreePBX, but I am not sure if that is also true for Wazo.