hawk#1
Well-Known Member
- Joined
- Nov 3, 2015
- Messages
- 716
- Reaction score
- 309
Sorry but I found another little error. this time it is in the end of the trunks tutorial. http://nerdvittles.com/?page_id=18280. At the very end:
Wazo will not actually process incoming and outgoing calls through the Simonics SIP Gateway trunk until you configure an outgoing route in IPBX:Call Management:Outgoing Calls and an incoming route using IPBX:Call Management:Outgoing Calls. Outgoing and Incoming call routing are covered in separate tutorials.
shouldn't this "an incoming route using IPBX:Call Management:Outgoing Calls."
be changed to "an incoming route using IPBX:Call Management:Incoming Calls. "
Wazo will not actually process incoming and outgoing calls through the Simonics SIP Gateway trunk until you configure an outgoing route in IPBX:Call Management:Outgoing Calls and an incoming route using IPBX:Call Management:Outgoing Calls. Outgoing and Incoming call routing are covered in separate tutorials.
shouldn't this "an incoming route using IPBX:Call Management:Outgoing Calls."
be changed to "an incoming route using IPBX:Call Management:Incoming Calls. "