jeremytourville
New Member
- Joined
- Jun 30, 2016
- Messages
- 6
- Reaction score
- 0
I installed this version of pbxiaf from github -incrediblepbx13-raspbian8-gvoauth.zip.
I did all the normal security updates from the script, configured my trunks, routes and extensions. Everything is working except getting my ATA to register to the PBX. My ATA is at the latest firmware release 1.4.1 from Cisco. I did a factory reset on the ATA to set everything stock and put in the extension, secret and made sure the port numbers matched. Both devices are one the same subnet. If I power cycle the device you can see it go from "not registered" to "failed" You can review my support thread over at Cisco forums if that helps.
https://supportforums.cisco.com/discussion/13060006/spa112-not-registering
I am able to get a softphone to register. The issue seems to be specific to my ATA. I did try turning on SIP debugging and looking through /var/log/asterisk/full. I can see in the log where the softphone registers but I don't see any activity from the ATA. Any thoughts on where to start on this?
I did all the normal security updates from the script, configured my trunks, routes and extensions. Everything is working except getting my ATA to register to the PBX. My ATA is at the latest firmware release 1.4.1 from Cisco. I did a factory reset on the ATA to set everything stock and put in the extension, secret and made sure the port numbers matched. Both devices are one the same subnet. If I power cycle the device you can see it go from "not registered" to "failed" You can review my support thread over at Cisco forums if that helps.
https://supportforums.cisco.com/discussion/13060006/spa112-not-registering
I am able to get a softphone to register. The issue seems to be specific to my ATA. I did try turning on SIP debugging and looking through /var/log/asterisk/full. I can see in the log where the softphone registers but I don't see any activity from the ATA. Any thoughts on where to start on this?