TIPS Incoming/Outgoing Calls are TOO QUIET on both ends

[Appleton6509]

PBX in a Flash
FreePBX 2.8.1.5 o
CentOS release 6.2 (Final)
2.6.32-220.17.1.el6.i686 (SMP) i686

- using stock system, no customization to any scripts other then whats required to make it work.
- phones are all using SIP
- SIP enable phones and softphones being used
- incoming calls connect to, 2 x Digium AEX410 4 port analog cards


Issue:
- incoming calls to sip enabled phones and softphones are very quiet on BOTH ends
- outgoing calls from sip enabled phones and softphones are very quiet on BOTH ends
- incoming calls that transfer to a CELL phone via cell # are very quiet on both ends


I am looking for a resolution to the above issues......help would be GREATLY appreciated.

 

[atsak]

you dont' say what version you're using of Asterisk, so I can't tell you exactly what to do, but the setting you need is rxgain and txgain and it goes in zapata.conf or chan_dahdi.conf I believe.

 

[Appleton6509]

Ahh that might help.

I looked that up and I read a forum that says if I want to change that setting I cant be using the dahdi module by freepbx as there is no way to keep the custom settings from getting overwritten? verifications?

freepbx.org/forum/freepbx/users/setting-txgain-and-rxgain
Asterisk (Ver. 1.8.13.0)

 

[tm1000]

That's incorrect. The module allows you to set that in the GUI an the module works pretty well these days

Ahh that might help.

I looked that up and I read a forum that says if I want to change that setting I cant be using the dahdi module by freepbx as there is no way to keep the custom settings from getting overwritten? verifications?

freepbx.org/forum/freepbx/users/setting-txgain-and-rxgain
Asterisk (Ver. 1.8.13.0)

 

[Appleton6509]

The GUI on my box is quite limited for setting for dahdi. what version was the gui updated on? im on freepbx version 2.8.1.5 and dahdi version is 2.8.0.1.....

 

[tm1000]

2.10+

 

[Appleton6509]

upgraded to 2.10. GUI for dahdi is much improved. got what I needed thanks