I have installed and reinstalled the ISO several times but no matter what I do, I keep getting this error when trying to send a fax with a cover page:
Install the ISO as a VM on Proxmox
reboot
/root/admin-pw-change
/root/timezone-setup
htpasswd /etc/pbx/wwwpasswd admin
./incrediblefax13.sh
reboot
log into Avant Fax
reset password
Attempt to send fax
I get this if I attach a PDF and add cover page:
and this if I just try the cover letter:
Sending a PDF with no cover page goes through normally.
Am I missing something obvious? I recently had this working fine with an exact same install on the same hardware with the same ISO. I can't figure out what's causing it to break on a fresh install. How can I test to see what's wrong with the system?
Problem sending the fax.
sendfax: /var/www/html/avantfax/tmp/afb078cb.ps: Empty file
This is with a brand new vanilla install. Here are the steps I've taken:sendfax: /var/www/html/avantfax/tmp/afb078cb.ps: Empty file
Install the ISO as a VM on Proxmox
reboot
/root/admin-pw-change
/root/timezone-setup
htpasswd /etc/pbx/wwwpasswd admin
./incrediblefax13.sh
reboot
log into Avant Fax
reset password
Attempt to send fax
I get this if I attach a PDF and add cover page:
Problem sending the fax.
sendfax: Error creating cover sheet; command was "/var/www/html/avantfax/includes/faxcover.php -C '/var/www/html/avantfax/images/cover-letter.ps' -f 'info' -n '9712751480' -r 'Test' -s 'default' -t 'Test' -M '[email protected]' -p '4'"; exit status ff00
sendfax: Error creating cover sheet; command was "/var/www/html/avantfax/includes/faxcover.php -C '/var/www/html/avantfax/images/cover-letter.ps' -f 'info' -n '9712751480' -r 'Test' -s 'default' -t 'Test' -M '[email protected]' -p '4'"; exit status ff00
and this if I just try the cover letter:
Problem sending the fax.
sendfax: /var/www/html/avantfax/tmp/afb078cb.ps: Empty file
sendfax: /var/www/html/avantfax/tmp/afb078cb.ps: Empty file
Sending a PDF with no cover page goes through normally.
Am I missing something obvious? I recently had this working fine with an exact same install on the same hardware with the same ISO. I can't figure out what's causing it to break on a fresh install. How can I test to see what's wrong with the system?