SOLVED DAHDI/g0 Question...

[sigmaz]

Hey gang, Here is a two part question that may be related to one another...

I have a pair of TDM800 cards installed and I can create outbound routes to each individual analog channel.

I can call out on DAHDI/1-1 when the line is plugged in but if I move the test line to say DAHDI/9-1 I get an all circuits busy..

It fails on the first disconnected port and doesn't jump to the actual attached one.

Another issue I see is that when I attempt to send a call out to DAHDI/g0 I get an 'all circuits are busy' error regardless of port connected to the test line, even port 1.

I tried both ascending and descending settings but there was no change.

So two issues, How do I get DAHDI/g0 working and/or how do I get DAHDI/x-1 to fail over to the next available port if one before it is disconnected?

Oh and I have manually added the 0 to the group association fields so they should know where they belong...

thanks guys.
Jon

 

[briankelly63]

check this for some background:

http://pbxinaflash.com/community/th...ard-using-dahdi-on-piaf-purple.11214/?t=11214

groups are set up in the dahdi-channels.conf file that is in etc/asterisk

 

[sigmaz]

Thanks for the heads up.. I'm tinkering..

this entry looks odd.. actually they all do.

all channels are listed but with two context lines?

; Span 1: WCTDM/0 "Wildcard TDM800P"
;;; line="1 WCTDM/0/0 FXSKS (In use)"
signalling=fxs_ks
callerid=asreceived
group=0
context=from-pstn
channel => 1
callerid=
group=
context=default

 

[sigmaz]

LOL! I really do appreciate the help.

 

[sigmaz]

Thanks for the heads up.. I'm tinkering..

this entry looks odd.. actually they all do.

all channels are listed but with two context lines?

; Span 1: WCTDM/0 "Wildcard TDM800P"
;;; line="1 WCTDM/0/0 FXSKS (In use)"
signalling=fxs_ks
callerid=asreceived
group=0
context=from-pstn
channel => 1
callerid=
group=
context=default

I guess when I ran the cfg tool it appended the new context, group, and cid lines to the existing entries..
Hmmm...

 

[sigmaz]

BTW, Ripping everything out and following the linked directions a few posts up worked perfectly.
Thanks guys!.