SOLVED Can't seem to configure a PJSIP Trunk

[AndyInNYC]

Nope, still having problems.

I have disabled all PJSIP 'stuff' and have two trunks - us-east-nj.sip.flowroute.com and us-east-va.sip.flowroute.com

flowroute uses a range of IP for us-east-nj.sip.flowroute.com the block starts at .192 and ends at .207.
My PBX uses us-east.nj.sip.flowroute.com and likely gets an initial IP (say .192) and that number then changes somewhere along the line and my phone reports to callers that it isn't in service (or whatever).

This is the line from the asterisk cli:

 Executing [s@from-sip-external:6] Log("SIP/fl.gg-0000000c", "WARNING,"Rejecting unknown SIP connection from 147.75.65.194"") in new stack
[2019-10-08 13:01:49] WARNING[17205][C-00000012]: Ext. s:6 @ from-sip-external: "Rejecting unknown SIP connection from 147.75.65.194"
    --

So, I'm back where I started with SIP still f'ing with me.

Ward, your PJSIP solution for bulkvs has multiple IPs marked for the same Trunk. Does this work with SIP? Could I add a line for each IP in the block for ...nj.sip.flowroute.com?

Please help. And let's unmark the 'Solved'.

 

[AndyInNYC]

A further bit of information. My PBX has two companies using it, each with a flowroute account. I've set both up to use flowroute's NJ and VA POPs.

If I look at 'sip show peers', I see this

flowrouteNJSIP_ASB/MyACCT 147.75.65.193                               Yes        Yes            5060     OK (7 ms)
flowrouteNJSIP_Ian/HisACCT 147.75.65.194                               Yes        Yes            5060     OK (11 ms)

As you'll note, they use different IP addresses (which will likely change again later). Both 'should' connect to the same IP.

This is killing me.

Andrew