Albert S
Member
- Joined
- Jul 21, 2013
- Messages
- 122
- Reaction score
- 7
Hi guys,
I am firing up PIAF boxes from pre-build images.
But once they are booted for the first time, under Asterisk SIP Settings, they have the IP information of the original PBX took the image from.
I'd like to click, or trigger the "Auto Configure" and "Apply Config" buttons. However I can't find which module this is part of and how to call it. (See the picture Step 1 and Step 2)
http://www.awesomescreenshot.com/image/1458940/584ddf48471e304260fcf6acd11f212e
How can I do this? I have played with AGI before and know how to connect to it but can't find where these options are in PIAF or FreePBX.
Thank you for reading and any suggestions in advance.
I am firing up PIAF boxes from pre-build images.
But once they are booted for the first time, under Asterisk SIP Settings, they have the IP information of the original PBX took the image from.
I'd like to click, or trigger the "Auto Configure" and "Apply Config" buttons. However I can't find which module this is part of and how to call it. (See the picture Step 1 and Step 2)
http://www.awesomescreenshot.com/image/1458940/584ddf48471e304260fcf6acd11f212e
How can I do this? I have played with AGI before and know how to connect to it but can't find where these options are in PIAF or FreePBX.
Thank you for reading and any suggestions in advance.