jbstanford
New Member
- Joined
- Dec 1, 2013
- Messages
- 7
- Reaction score
- 3
Hello all,
Thank you all for your great work on iris3000. I'm having some issues with mine and have been trying for awhile:
If I reset with 1*# connected to the Internet it downloads latest from ACN and boots fine, can get into menus, etc; I can factory reset with password and SSH with root/acnum3c (root/root after factory reset). But, no WebUI. -> Can I just manually modify files to get it to connect to my server? I also have full network control and could redirect IPs/DNS etc.
If I try and update with sd card or update from ISO it will reboot and can go through the 1*# fine (white progress bar/restore) but then it just sits on ACN World logo for hours.
I got into Redboot and following #101, I ran the fis load kernel and got the "warning - checksum failure." so I followed the steps there. Now it goes through the white background (red progress bar) steps successfully but again stays stuck on the world screen. I can run fis load kernel with no errors, but it goes back to the world screen and stays there without moving on.
What should I do/try at this point? Is there an SD Card image that is worth trying, since that worked in the past but I couldn't get it set up? Can I run on stock firmware and modify files manually via ssh?
Unsure of the best route to proceed, but I'd like to get this working. I can go down the road of a serial console and such if that's helpful - let me know the best next steps. Thank you for your help!
Thank you all for your great work on iris3000. I'm having some issues with mine and have been trying for awhile:
If I reset with 1*# connected to the Internet it downloads latest from ACN and boots fine, can get into menus, etc; I can factory reset with password and SSH with root/acnum3c (root/root after factory reset). But, no WebUI. -> Can I just manually modify files to get it to connect to my server? I also have full network control and could redirect IPs/DNS etc.
If I try and update with sd card or update from ISO it will reboot and can go through the 1*# fine (white progress bar/restore) but then it just sits on ACN World logo for hours.
I got into Redboot and following #101, I ran the fis load kernel and got the "warning - checksum failure." so I followed the steps there. Now it goes through the white background (red progress bar) steps successfully but again stays stuck on the world screen. I can run fis load kernel with no errors, but it goes back to the world screen and stays there without moving on.
What should I do/try at this point? Is there an SD Card image that is worth trying, since that worked in the past but I couldn't get it set up? Can I run on stock firmware and modify files manually via ssh?
Unsure of the best route to proceed, but I'd like to get this working. I can go down the road of a serial console and such if that's helpful - let me know the best next steps. Thank you for your help!