newbie

  1. J

    NEED MORE INFO Asterisk not running on Incredible PBX 14 WAZO

    I just installed Incredible PBX 14 WAZO, Asterisk is Down, did I do something wrong?
  2. J

    QUESTION Provisioning Cisco IP7960's on Incredible PBX

    Hi there, I am running an Incredible PBX server and want to provision 7 Cisco IP 7960 phones, Can I provision them without t*f*t*p? If so How? and if not, how do I run t*f*t*p on Incredible PBX 12.0.70, Incredible GUI 12.0.30, and running Asterisk 13.9.1. Using Vitelity Trunks.
  3. J

    QUESTION Provisioning Polycom phones

    I am trying to provision Polycom phones, IP 501, IP 300, IP 550 and IP 650 with no luck. IP 550 is receiving all details via web GUI but when go to make a call it displays "URL Calling is disabled". Anybody got any ideas? I am using Incredible PBX 12.0.70 Asterisk 13.9.1 I have the PBX on a...
  4. J

    SOLVED IncrediblePBX Softphone not registering

    I did an install of Incredible PBX/Fax 13-12.2 Running Asterisk 13.9.1, Incredible GUI 12.0.30 on a cloud at cost server using Centos 6.7, and I can't seem to register a softphone. I have tried Zoiper and Media5 both on android and IOS. I have whitelisted IP address. My outbound trunk settings...
  5. J

    QUESTION How can I get PIAF-Green to receive Faxes?

    I set up an inbound route and pointed a did to it. I set it to receive faxes.
  6. J

    TIPS Vitelity Trunk, Outbound route "All Circuits are busy right now"

    I finally got my inbound route to work but my outgoing route is registering but i get the "all circuits are busy now". Any ideas? Please advise. Thanks in advance Jose Casares
  7. J

    TIPS Not able to access Web GUI

    I installed PIAF 11-11.2 with Asterisk 11.21.2 Incredible GUI 2.11.0.34 i did the /root/admin-pw-change but I am not able to reach server. Any ideas or suggestions?
  8. John Lussmyer

    GO HERE Initial System setup/configuration

    I now have a Raspberry Pi 2, with Asterisk/Freepbx installed. I'm having problems finding documentation on how to do all the initial configuration and setup via the GUI. I hadn't realized how much more involved it is than my old little standalone PBX system. (8 exts, 4 lines) The docs referenced...