extension

Can I connect a standard sip software client, like MicroSip or Linphone or similar to 3CX extensions ?

Hello everyone, I have a problem completing the setup of a Cisco phone. This is what I did: Set up a Raspbx Configured 3 SIP softphones. Added a Cisco 6901 SCCP phone as following: Installed SCCP module with: apt-get update apt-get install chan-sccp-ast16 Set pbx ip address as t*f*t*p server...

Hey guys I am trying to work out a way in which I could block all prefixes and then I can allow all of them in order to make sure that my colleagues are writing correct phone numbers when dialing. The thing is I can not find anything on that matter, it is like asterisk can not provide a certain...

Newbe to IPBX 13-13.10, lost in how to configure & register Yealink phones: I set up incredible PBX 13-13.10 for Raspbian on a Raspberry PI 3 B+ (http://nerdvittles.com/?p=21255) have managed to get it to register with our SIP.US trunks but I have yet to figure out how to create extensions...

Hello everybody.. I have elastix server and nortel ip phone 1120e sip phone , I have created domain in ip phone :.. Server.. 10.0.0.43 which is elastix server and it taked ip from dhcp server.. I made a ping from sever to phone and it replied... Also ping from phone to server and gateway and...

Hello How do i include another dialplan file to from-internal context (IPBX 13-12.3)? Number: 1 I add [from-pstn-custom] context to extension_custom.conf. Is there any way to change this context name and extension.conf too? How Do i include external file? Number : 2 Incoming call from PSTN to...

Hi there, I'm trying to configure NAT mode for some PJSIP extensions in Incredible PBX 13-13, but there doesn't seem to be a 'NAT Mode' setting in the Advanced tab for each extension.. I can see it there for normal SIP extensions, but not PJSIP. Is it not possible to configure NAT mode for...

Looking at dispatching priority support via IVR (i.e. answer the call, validate customer ID, dispatch that client name to a shell script that sends out SMS ever five minutes until acknowledged). Can't find a construct that would allow a destination/extension/? to invoke a shell script...

I've two active trunks. Both are for same calling route, to call India. Now I want a single trunk to use for only one extension. Outbound Rules are same as bellow: Outbound Prepend Prefix Match Pattern CallerID 1 +91XXXXXXXXXX 2...