Hi,
I have installed pbxinaflash and have created several trunks with the intention that a specific extension should only use a specific trunk.
I've create outbound routes to match and have selected the appropriate trunk to be used.
I now find that either calls cannot be made for one of the following 2 reasons
1. 'All circuits are busy now'
2. I get an enaged tone.
Sometimes I can make calls but these all get shown as coming from the same number. I'm hoping someone call give me some help so that for example
extn 1000 uses trunk A and the CID is trunk A
extn 1100 uses trunk B and the CID is trunk B
and so on.
I would prefer not to have to use a different number prefix for each
Any help would be greatly appreciated.
Jonathan Hamon
I have installed pbxinaflash and have created several trunks with the intention that a specific extension should only use a specific trunk.
I've create outbound routes to match and have selected the appropriate trunk to be used.
I now find that either calls cannot be made for one of the following 2 reasons
1. 'All circuits are busy now'
2. I get an enaged tone.
Sometimes I can make calls but these all get shown as coming from the same number. I'm hoping someone call give me some help so that for example
extn 1000 uses trunk A and the CID is trunk A
extn 1100 uses trunk B and the CID is trunk B
and so on.
I would prefer not to have to use a different number prefix for each
Any help would be greatly appreciated.
Jonathan Hamon