Aaron Unpublished
New Member
- Joined
- May 24, 2013
- Messages
- 11
- Reaction score
- 0
Is there a known issue of TCP not working on the latest version of PBX In A Flash?
I enabled TCP by going to Settings/Asterisk SIP Settings and adding the following:
tcpenabled
transport=tcp
However, the PBX Box isn't even listening on TCP it doesn't seem like...
root:~ $ telnet 10.40.XXX.XXX 5060
Trying 10.40.XXX.XXX...
telnet: connect to address 10.40.XXX.XXX: Connection refused
I also setup an extension as a test.. Set transport as TCP Only. Then setup the device to use TCP only. It fails. Won't connect to PBX.
Disabled iptables and fail2ban thinking one of these were blocking it and still no luck.
Am I missing something?
Update: Never mind
I noticed I had "tcpenabled=yes" and it should have been "tcpenable=yes" Sorry!
I enabled TCP by going to Settings/Asterisk SIP Settings and adding the following:
tcpenable
transport=tcp
However, the PBX Box isn't even listening on TCP it doesn't seem like...
root:~ $ telnet 10.40.XXX.XXX 5060
Trying 10.40.XXX.XXX...
telnet: connect to address 10.40.XXX.XXX: Connection refused
I also setup an extension as a test.. Set transport as TCP Only. Then setup the device to use TCP only. It fails. Won't connect to PBX.
Disabled iptables and fail2ban thinking one of these were blocking it and still no luck.
Am I missing something?
Update: Never mind
I noticed I had "tcpenabled=yes" and it should have been "tcpenable=yes" Sorry!
Phone System 