BUG Speed dial and DAHDI

[AndyInNYC]

I have a newly installed GREEN on a local machine to run my phones. I have a SIP phone and an analog phone attached via a Digium TDM800 w/hardware EC.

status returns:

                            x  Asterisk  = ONLINE  | Dahdi    = ONLINE  | MySQL    = ONLINE    x
                            x  SSH        = ONLINE  | Apache    = ONLINE  | Iptables  = ONLINE    x
                            x  Fail2ban  = ONLINE  | Internet  = ONLINE  | Ip6Tables = ONLINE    x
                            x  Disk Free  = ADEQUATE| Mem Free  = ADEQUATE| NTPD      = ONLINE    x
                            x  SendMail  = ONLINE  | Samba    = OFFLINE | Webmin    = ONLINE    x
                            x  Ethernet0  = ONLINE  | Ethernet1 = N/A    | Wlan0    = N/A      x
                            x                                                                    x
                            x  PIAF Installed Version  = 2.0.6.5 under *HARDWARE*                x
                            x  FreePBX Version          = 2.11.0.38                              x
                            x  Running Asterisk Version = 11.10.0                                x
                            x  Asterisk Source Version  = 11.10.0                                x
                            x  Dahdi Source Version    = 2.9.0                                  x
                            x  Libpri Source Version    = 1.4.14                                  x
                            x  IP Address              = 192.168.40.29 on eth0                  x
                            x  Operating System        = CentOS release 6.5 (Final)              x
                            x  Kernel Version          = 2.6.32-431.1.2.0.1.el6.x86_64 - 64 Bit  x
                            x  Incredible Version      = 11.10                                  x

I have a speed dial defined in the phonebook. The number is 18005551212 set to speed dial 10.

If I dial *010 from my SIP phone I get connected to 18005551212. If I dial the phone number it works as well.

If I dial *010 from the analog phone I get a busy signal. The asterisk CLI returns:
-- Starting simple switch on 'DAHDI/8-1'

When I hang up the CLI reports:
-- Hanging up on 'DAHDI/8-1'
-- Hungup 'DAHDI/8-1'

If I dial the number normally on the analog phone it connects to the number.

I have done a reinstall once, so the problem persists.

If this post is a dupe, I apologize - the site seems to have eaten my last post moments ago on this subject.

Andrew

 

[AndyInNYC]

Can someone with analog phones and SIP phones check their speed dials to see if I'm the only one with this problem?

Andrew