rick
Member
- Joined
- Dec 30, 2008
- Messages
- 148
- Reaction score
- 12
Asterisk = ONLINE | Dahdi = ONLINE | MySQL = ONLINE x
x SSH = ONLINE | Apache = ONLINE | Iptables = ONLINE x
x Fail2ban = ONLINE | Internet = ONLINE | Ip6Tables = ONLINE x
x Disk Free = ADEQUATE| Mem Free = ADEQUATE| NTPD = ONLINE x
x SendMail = ONLINE | Samba = OFFLINE | Webmin = ONLINE x
x Ethernet0 = ONLINE | Ethernet1 = N/A | Wlan0 = N/A x
x PIAF Installed Version = 2.0.6.5 under *HARDWARE* x
x FreePBX Version = 2.11.0.38 x 2.11
x Running Asterisk Version = 11.7.0 x
x Asterisk Source Version = 11.7.0 x
x Dahdi Source Version = 2.8.0.1 x
x Libpri Source Version = 1.4.14 x
x IP Address = 192.168.0.250 on eth0 x
x Operating System = CentOS release 6.5 (Final) x
x Kernel Version = 2.6.32-431.1.2.0.1.el6.i686 - 32 Bit
PBXiaF = Green
Problem: followme will not dial out, message saying "all circuits are busy."
Can dial manually on any phone to any number but when freepbx is setup to dial out to a cell phone using either Ring group or followme , get the message "all circuits are busy". Tried using area code, 1+ AC and the number alone. This pbx is attached to a PRI, Digium te133
x SSH = ONLINE | Apache = ONLINE | Iptables = ONLINE x
x Fail2ban = ONLINE | Internet = ONLINE | Ip6Tables = ONLINE x
x Disk Free = ADEQUATE| Mem Free = ADEQUATE| NTPD = ONLINE x
x SendMail = ONLINE | Samba = OFFLINE | Webmin = ONLINE x
x Ethernet0 = ONLINE | Ethernet1 = N/A | Wlan0 = N/A x
x PIAF Installed Version = 2.0.6.5 under *HARDWARE* x
x FreePBX Version = 2.11.0.38 x 2.11
x Running Asterisk Version = 11.7.0 x
x Asterisk Source Version = 11.7.0 x
x Dahdi Source Version = 2.8.0.1 x
x Libpri Source Version = 1.4.14 x
x IP Address = 192.168.0.250 on eth0 x
x Operating System = CentOS release 6.5 (Final) x
x Kernel Version = 2.6.32-431.1.2.0.1.el6.i686 - 32 Bit
PBXiaF = Green
Problem: followme will not dial out, message saying "all circuits are busy."
Can dial manually on any phone to any number but when freepbx is setup to dial out to a cell phone using either Ring group or followme , get the message "all circuits are busy". Tried using area code, 1+ AC and the number alone. This pbx is attached to a PRI, Digium te133