TUTORIAL Anveo.com trunk setup

[edisoninfo]

Is the setup method in the original article back in May, 2013 still the recommended way to connect to Anveo? I noticed it uses several separate trunks with actual IP addresses instead of just sip.anveo.com as their web documentation shows. My concern is if those IP's are still valid? If I ping sip.anveo.com I do not get any of those IP's in the article. Since that was almost a year ago, has enough things changed that is is OK now to use a normal single trunk setup and sip.anveo.com ?

 

[Chris Sweeney]

Not sure but for Anveo Direct their support still says to use the following setups:

Anveo Direct uses IP authentication for outgoing calls and incoming calls are sent to SIP URI so there is no need to "register" SIP server.​

To place calls though Anveo Direct you need to create a peer as following​

[anveo_direct_out]
type=peer
host=sbc.anveo.com
port=5060
insecure=port,invite
canreinvite=yes
disallow=all
allow=ulaw

To receive calls from Anveo Direct you need to create a number of peers (with separate IP addresses) and then handle incoming calls in from-anveo-direct context on your server.​

[anveo_direct_in_67.212.84.21]
host=67.212.84.21
type=friend
insecure=port,invite
context=from-anveo-direct
canreinvite=yes
qualify=no
disallow=all
allow=ulaw
allow=g729

[anveo_direct_in_176.9.39.206]
host=176.9.39.206
type=friend
insecure=port,invite
context=from-anveo-direct
canreinvite=yes
qualify=no
disallow=all
allow=ulaw
allow=g729

[anveo_direct_in_50.22.102.242]
host=50.22.102.242
type=friend
insecure=port,invite
context=from-anveo-direct
canreinvite=yes
qualify=no
disallow=all
allow=ulaw
allow=g729

[anveo_direct_in_50.22.101.14]
host=50.22.101.14
type=friend
insecure=port,invite
context=from-anveo-direct
canreinvite=yes
qualify=no
disallow=all
allow=ulaw
allow=g729

[anveo_direct_in_72.9.149.25]
host=72.9.149.25
type=friend
insecure=port,invite
context=from-anveo-direct
canreinvite=yes
qualify=no
disallow=all
allow=ulaw
allow=g729