On the old freepbx system, under 'connectivity" and "trunks" I created a SIP account for "anveo" and then pasted in "peer details" and "registration string" and could get the trunk online in no time.
Now, with my new raspberry pi 2, incrediblepbx running Asterisk/11.19.0, the GUI is so different. I entered the following under Trunk:
hostname:anveo.sip.com
username: anveo username
password: anveo password
callerID: XXXXXXXXXXX
FromDomain: sip.anveo.com
FromUser: anveo username
Authuser: anveo username (or do I leave blank?)
Insecure: very (is this right?)
Outbound proxy: sip.anveo.com
There is no place to paste "peer details" so I added them to the end of sip.conf
I also added "register => ACCOUNT_NUMBER:[email protected]:5010" to the [general] section.
Trunk status is "Request"
Does anyone know how I can get the Truck to connect? Thanks in advance from a novice.
Now, with my new raspberry pi 2, incrediblepbx running Asterisk/11.19.0, the GUI is so different. I entered the following under Trunk:
hostname:anveo.sip.com
username: anveo username
password: anveo password
callerID: XXXXXXXXXXX
FromDomain: sip.anveo.com
FromUser: anveo username
Authuser: anveo username (or do I leave blank?)
Insecure: very (is this right?)
Outbound proxy: sip.anveo.com
There is no place to paste "peer details" so I added them to the end of sip.conf
I also added "register => ACCOUNT_NUMBER:[email protected]:5010" to the [general] section.
Trunk status is "Request"
Does anyone know how I can get the Truck to connect? Thanks in advance from a novice.