QUESTION Using Routes to change callerID for outgoing calls

[mathewjenkinson]

Hi all,

Im using a single SIP truck where I can pass three CallerID's to make outgoing calls.

+1415...
+1404...
+1513...

I currently have the route plans setup, so that calls to 415 +1415 numbers use the +1415 callerID and calls to +14404 numbers use the +1404 callerID, but I can't seem to write a catch all where calls to other area codes use the 513 number.

I tried using +1. but this catches everything first rather than last.
do I need to create a 3rd route with all the other area codes mapped to 513?
Or is there a way to specify a way to tell PbxIAF to read this route plan first, then this route plan then fall back to 513?

Thanks
Mathew

 

[billsimon]

The outbound routes work in the order listed. So you can put your specific routes at the top, then the catch-all outbound route at the bottom of the list to do what you want.

 

[mathewjenkinson]

Bingo!
Thank you very much BillSimon, I was not aware of the routing order listing.